A timeout value in milliseconds. Windows forwards all the broadcast or multicast frames to the INtime node. The following are major changes in the implementation of the network software, and are designed to pull the stack closer to a standard implementation. In this mode the driver polls the status register instead of relying on the interrupt from the device. The buffer must be at least bytes long. Failed to look up cntName.

Uploader: Akizuru
Date Added: 14 August 2008
File Size: 31.31 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 58876
Price: Free* [*Free Regsitration Required]

Need manual route settings if the INtime node needs to communicate to other network devices.

They are listed by their manufacturer’s product name. It is up to the user not to open the same device multiple times at the same time. Advanced Networking Documentation FreeBSD provides a really good resource for advanced networking concepts and operations. Error in accessing XCNT’s shared 1093.

Set the etyernet to one of the given values. There may be the additional requirement that network access from INtime be more “real-time” than bridging from Windows may allow. These are the bridging statements from netuser.

CONFIG_E100: Intel(R) PRO/100+ support

To find these, if the part is installed in the system and Windows is booted, go to the Windows Device Manager devmgmt. Parameters pHandle A pointer to a handle. Buffer for transmission is full.


Legacy network support drivers This page refers to the legacy network stack which was shipped with INtime versions prior to 4. Converting your project Some project settings need to change to recompile your application to use the new stack.

For example, the first connector device name will be “xcnt0”.

Special options for the e driver are as follows: This broadcast is not forwarded by routers so will only appear on one network segment. See this article for details. Due to the Spanning Tree Algorithmit may take 10 to 12 seconds for the Windows bridge to allow packets to pass through from the INtime portion of the bridge.

This is best when the INtime node doesn’t need to communicate with any network devices other than the Windows on the same PC.

I have a network application I wrote in a previous version of Ethernwt, what do I have to do to convert it to run erhernet the new network stack? Using Subnet In this configuration, INtime node looks as if it is connected through a router. If you turn on the debug traces, then you may see a message, something like “MSI not usable” if the driver determined that the device has the MSI issue.

Disadvantages All multicast and broadcast frames sent and received by other Windows network connections that are linked into the bridge will be sent to the INtime interface, and vice versa. Length of the frame including the Ethernet header destination address, source address and ether-type but excluding FCS checksum. For example, the first connector device will be “xcnt0”. The solution is 10339 disable the STA.


INtime Networking

For example, there is a family of Intel parts, which are variations on the chipset versions of the Etehrnet x components. Change the Media Status for the connector device. Specifies the MAC address for the device.

The Media Status is detected by istack for example, the ifconfig. Remove the comment character ‘ ‘ before the bridging statement lines in the field.

Override the default interface name. Bridging on Windows Side. Routers may be configured to forward directed broadcasts on large networks. Intel publishes the issue in errata section of their “Specification Update” documents. The buffer must be at least bytes long.